Bug 119802

Here the interesting enty in /etc/sysconfig/kernel: 
 
INITRD_MODULES="ata_piix mptspi qla2300 processor thermal fan reiserfs" 
 
Without mptspi the qla2300 driver doesn't find any devices. Is mptspi needed 
for qla2300 or is the qla2300 problem an other problem? However, without Xen 
both drivers will worke fine: 
 
Fusion MPT base driver 3.03.02 
Copyright (c) 1999-2005 LSI Logic Corporation 
mptspi: module not supported by Novell, setting U taint flag. 
Fusion MPT SPI Host driver 3.03.02 
mptbase: Initiating ioc0 bringup 
ioc0: 53C1030: Capabilities={Initiator} 
scsi2 : ioc0: LSI53C1030, FwRev=01032316h, Ports=1, MaxQ=222, IRQ=177 
  Vendor: IBM       Model: 25P3495a S320  1  Rev: 1 
  Type:   Processor                          ANSI SCSI revision: 02 
Attached scsi generic sg1 at scsi2, channel 0, id 8, lun 0,  type 3 
QLogic Fibre Channel HBA Driver 
qla2300 0000:04:02.0: Found an ISP2312, irq 169, iobase 0xf8834000 
qla2300 0000:04:02.0: Configuring PCI space... 
qla2300 0000:04:02.0: Configure NVRAM parameters... 
qla2300 0000:04:02.0: Verifying loaded RISC code... 
qla2300 0000:04:02.0: Waiting for LIP to complete... 
qla2300 0000:04:02.0: LIP reset occured (f7f7). 
qla2300 0000:04:02.0: LOOP UP detected (2 Gbps). 
qla2300 0000:04:02.0: Topology - (F_Port), Host Loop address 0xffff 
scsi3 : qla2xxx 
qla2300 0000:04:02.0: 
 QLogic Fibre Channel HBA Driver: 8.01.00b5-k 
  QLogic QLA2340 - 133MHz PCI-X to 2Gb FC, Single Channel 
  ISP2312: PCI-X (100 MHz) @ 0000:04:02.0 hdma+, host#=3, fw=3.03.15 IPX 
qla2300 0000:05:01.0: Found an ISP2312, irq 185, iobase 0xf8836000 
qla2300 0000:05:01.0: Configuring PCI space... 
qla2300 0000:05:01.0: Configure NVRAM parameters... 
qla2300 0000:05:01.0: Verifying loaded RISC code... 
qla2300 0000:05:01.0: Waiting for LIP to complete... 
  Vendor: IBM       Model: 1722-600          Rev: 0520 
  Type:   Direct-Access                      ANSI SCSI revision: 03 
SCSI device sda: 41943040 512-byte hdwr sectors (21475 MB) 
SCSI device sda: drive cache: write back 
SCSI device sda: 41943040 512-byte hdwr sectors (21475 MB) 
SCSI device sda: drive cache: write back 
 sda: sda1 sda2 sda3 sda4 
Attached scsi disk sda at scsi3, channel 0, id 0, lun 0 
Attached scsi generic sg2 at scsi3, channel 0, id 0, lun 0,  type 0 
  Vendor: IBM       Model: 1722-600          Rev: 0520 
  Type:   Direct-Access                      ANSI SCSI revision: 03 
SCSI device sdb: 629145600 512-byte hdwr sectors (322123 MB) 
SCSI device sdb: drive cache: write back 
SCSI device sdb: 629145600 512-byte hdwr sectors (322123 MB) 
SCSI device sdb: drive cache: write back 
 sdb: sdb1 
Attached scsi disk sdb at scsi3, channel 0, id 0, lun 1 
Attached scsi generic sg3 at scsi3, channel 0, id 0, lun 1,  type 0 
  Vendor: IBM       Model: 1722-600          Rev: 0520 
  Type:   Direct-Access                      ANSI SCSI revision: 03 
SCSI device sdc: 10485760 512-byte hdwr sectors (5369 MB) 
SCSI device sdc: drive cache: write back 
SCSI device sdc: 10485760 512-byte hdwr sectors (5369 MB) 
SCSI device sdc: drive cache: write back 
 sdc: sdc1 sdc2 
Attached scsi disk sdc at scsi3, channel 0, id 0, lun 2 
Attached scsi generic sg4 at scsi3, channel 0, id 0, lun 2,  type 0 
  Vendor: IBM       Model: 1722-600          Rev: 0520 
  Type:   Direct-Access                      ANSI SCSI revision: 03 
SCSI device sdd: 10485760 512-byte hdwr sectors (5369 MB) 
SCSI device sdd: drive cache: write back 
SCSI device sdd: 10485760 512-byte hdwr sectors (5369 MB) 
SCSI device sdd: drive cache: write back 
 sdd: sdd1 sdd2 
Attached scsi disk sdd at scsi3, channel 0, id 0, lun 3 
Attached scsi generic sg5 at scsi3, channel 0, id 0, lun 3,  type 0 
  Vendor: IBM       Model: 1722-600          Rev: 0520 
  Type:   Direct-Access                      ANSI SCSI revision: 03 
SCSI device sde: 10485760 512-byte hdwr sectors (5369 MB) 
SCSI device sde: drive cache: write back 
SCSI device sde: 10485760 512-byte hdwr sectors (5369 MB) 
SCSI device sde: drive cache: write back 
 sde: sde1 sde2 
Attached scsi disk sde at scsi3, channel 0, id 0, lun 4 
Attached scsi generic sg6 at scsi3, channel 0, id 0, lun 4,  type 0 
  Vendor: IBM       Model: 1722-600          Rev: 0520 
  Type:   Direct-Access                      ANSI SCSI revision: 03 
SCSI device sdf: 151399694 512-byte hdwr sectors (77517 MB) 
SCSI device sdf: drive cache: write back 
SCSI device sdf: 151399694 512-byte hdwr sectors (77517 MB) 
SCSI device sdf: drive cache: write back 
 sdf: sdf1 sdf2 
Attached scsi disk sdf at scsi3, channel 0, id 0, lun 5 
Attached scsi generic sg7 at scsi3, channel 0, id 0, lun 5,  type 0 
  Vendor: IBM       Model: Universal Xport   Rev: 0520 
  Type:   Direct-Access                      ANSI SCSI revision: 03 
SCSI device sdg: 40960 512-byte hdwr sectors (21 MB) 
SCSI device sdg: drive cache: write through 
SCSI device sdg: 40960 512-byte hdwr sectors (21 MB) 
SCSI device sdg: drive cache: write through 
 sdg: unknown partition table 
Attached scsi disk sdg at scsi3, channel 0, id 0, lun 31 
Attached scsi generic sg8 at scsi3, channel 0, id 0, lun 31,  type 0 
  Vendor: IBM       Model: ULT3580-TD2       Rev: 4772 
  Type:   Sequential-Access                  ANSI SCSI revision: 03 
Attached scsi generic sg9 at scsi3, channel 0, id 1, lun 0,  type 1 
st: Version 20050501, fixed bufsize 32768, s/g segs 256 
  Vendor: IBM       Model: ULT3581-TA2       Rev: 3.00 
  Type:   Medium Changer                     ANSI SCSI revision: 02 
Attached scsi generic sg10 at scsi3, channel 0, id 1, lun 1,  type 8 
Attached scsi tape st0 at scsi3, channel 0, id 1, lun 0 
... 
 

Same problem with i386 installation. 

please report bugs for openSUSE against SUSE 10.0 and take a look at:  http://
www.opensuse.org/index.php/Submit_a_bug befor report a bug

***  S O L V E D  ***

A new BIOS update has solved my ACPI problems. And with running ACPI the xen 
kernel does booting without any problems.

Stephan

ok