Bugzilla – Bug 733118
br0 wont start on boot
Last modified: 2012-02-15 20:00:18 UTC
User-Agent: Mozilla/5.0 (Windows NT 5.1; rv:8.0.1) Gecko/20100101 Firefox/8.0.1 For OpenVPN use, I config in openSUSE 11.3, my network interfaces as is it: - eth0: 0.0.0.0/32, Firewall Disabled. - tap0: Only interface owner (nobody, nogroup), Internal Zone Firewall. - br0: 192.168.x.x/28 (Bridged Devices: eth0, tap0), External Zone Firewall. - Gateway: The router IP address on br0. But after a clean install of openSUSE 12.1, the br0 interface, wont start on boot. Reproducible: Always Steps to Reproduce: 1. On clean install, I select the bridge-utils package. 2. After, on Network Settings I config the network devices for bridge use. 3. The package for tap0 (tunctl) was fail to install in this step, then I install after from the repo. Actual Results: Only start on boot the eth0 device. br0 & tap0 starts manually with the ifup command. But is a bad idea.
Yes... a problem to install them while configuration in 2nd stage results in a failure... Going to add the utilities as requirements in the spec -- changelog: - Added to require vlan, bridge-utils and tunctl packages via spec, that are often required in base networking configurations and are missed otherwise in 2nd installation stage, that may be unable to install them for some reason. and apply to the update candidate at: http://download.opensuse.org/repositories/home:/mtomaschewski:/branches:/openSUSE:/12.1:/Update:/Test/ OK from your point of view?
This is an autogenerated message for OBS integration: This bug (733118) was mentioned in https://build.opensuse.org/request/show/99577 12.1 / sysconfig
This is an autogenerated message for OBS integration: This bug (733118) was mentioned in https://build.opensuse.org/request/show/99585 12.1 / sysconfig
fixed & submitted.
This is an autogenerated message for OBS integration: This bug (733118) was mentioned in https://build.opensuse.org/request/show/105293 Factory / sysconfig